Models Covered - Mitsubitshi
- Toyota - Lexus - Nissan - Honda
Parallel measurement is one of the ways in which we do measure vehicle
electronics. This way of measurement gives you the values going
into and out from the ECU*.
All the values are displayed in real time.
The connection to the car is fitted between the ECU and the ECU
harness using one of our cable adaptors
The Parallel way of measuring is in many cases the only way to
measure on cars from the time before OBD. But even on cars with
OBD the Parallel measure is of a great value when it comes to the
exact localisation of a fault.
*ECU = Electronic Control Unit
Serial measurement is the most common way to perform tests on
vehicle electronics. In modern cars a standard connector can be
found. From this connector we read the cars diagnostic system codes
and data’s. This diagnostic system is called OBD (On Board
By this technology it is in most cases also possible to activate
components, turn off service lamps, erase fault codes. test airbag
components, re-program immobiliser units,keys, and read Data.
To contact us use the form below - see what we can do for